Experimental Simulation Analysis for Single Phase Transformer Tests
AbstractThis article describes a workflow executed with MATLAB simulation and practical measurements for single phase power transformer. In addition, no-load, short-circuit test and load test are achieved in this work. The test procedures are implemented on a real transformer (terco–type) which has specifications of (1KVA, 220/110V, 50Hz). Finally, the simulation results are appeared proximately similar from the practical results.
 KV Atransformer, on website:www.tercosweder.com
 Andrea Ljubljana, ''Basic Principle and Operation of a Transformer'', University of Ljubljani Fakulteta 20 electrofebniko Trzaka 25, 1000 Ljublijana, Slovenija, March 2018.
 G. Aponte, H. Cadavid, J. C. BURGDS, ''A Methodology for Obtaining by Measurements the Transformer Physical-circuital Model Parameters'', Universidad Carios III (3), ISSN 0033-2097, R. 88 NR 9a/2012.
 J. Baraniak, K. Pachowicz, A. Nafalski, H. Considine, &Zorica, ''Determination of Parameters of an Equivalent Circuit of a Single-Phase Transformer using a Remote Laboratory'', World Transactions on Engineering and Technology Education, Vol. 14, No. 4, 2016.
 R. Majumder, S. Ghosh, R. Mukherjee, ''Transient Analysis of Single Phase Transformers Using State Model'', International Journal of Innovative Research in Science, Engineering and Technology, Vol. 5, Issue 3, March 2016.